作成者 |
|
|
|
|
本文言語 |
|
出版者 |
|
|
発行日 |
|
収録物名 |
|
巻 |
|
号 |
|
開始ページ |
|
終了ページ |
|
出版タイプ |
|
アクセス権 |
|
Crossref DOI |
|
権利関係 |
|
概要 |
Process temperature greatly affects the decomposition behavior of a blowing agent, and changes the structure of the porous epoxy. This paper investigates the effect of processing temperature on the de...composition rate and volume of decomposing gases from ammonium bicarbonate as well as the properties of porous epoxy micro-bead through a single epoxy droplet. A single epoxy droplet (epoxy-polyamide-ammonium bicarbonate) was dropped into the corn oil heated at the temperatures of 80°C, 90°C and 100°C. This study found that by controlling the processing temperature, an epoxy foam bulk (80°C) or a number of porous epoxy micro-beads were fabricated (90°C and 100°C). Higher total volume of gas was generated which was 1142.86 cm3/g at 100°C, with lower viscosity of epoxy. Therefore, the initial epoxy droplet of 10:6 ratio burst into smaller micro-beads with dominant sizes in the range of 251-500 μm and porosity of 30%. From the perspective of epoxy polyamide ratios, the 10:10 ratio has porous epoxy micro-beads slightly larger than that of 10:6 ratio. This induced a decrease in porosity and an increase in specific gravity of micro-beads of 10:10 ratio.続きを見る
|