作成者 |
|
|
|
|
|
|
|
本文言語 |
|
出版者 |
|
発行日 |
|
収録物名 |
|
巻 |
|
号 |
|
開始ページ |
|
終了ページ |
|
出版タイプ |
|
アクセス権 |
|
権利関係 |
|
|
関連DOI |
|
関連URI |
|
関連HDL |
|
概要 |
This paper presents the aggregation of asphaltenic materials in three dead crude oils, including two heavy samples from Hokkaido (Japan) and an extra heavy sample from Canada. In this study, a modifie...d ASTM D3279 method and PVT test were used to estimate the amount of precipitated asphaltene and the experimental bubble-point pressures of the samples, respectively. Upon which, a crude oil characterization was performed following pseudocomponent approach with the use of molecular weight and specific gravity of single carbon number from oil assay data as distribution variables. A simplified thermodynamic model, derived from the solubility model, was used to correlate the maximum asphaltene soluble with the aggregated amount. This study has highlighted that oil precipitation, during its titration, occurs as a function of both the molecular weight of the titrant and the carbon-to-hydrogen ratio in the asphaltene phase. Furthermore, the kinetics and the stability of intermolecular forces, developed during the miscibility process, are believed to alter oil polarity and gas solubility. More specifically, pressurization of the system [oil-supercritical gas] decreases the solubility parameters of the asphaltene fraction and increases the solvating strength of gas. Both effects were found to occur concurrently. This study has also demonstrated that asphaltenes are less soluble in impure gases compared to the pure one. At/near the bubble-point pressure, the supercritical gas, in contact with the oil, develops a potential as either a flocculant or coagulant. The increase in pseudo equilibrium temperature attained after gas injection was found also to alter asphaltene aggregation.続きを見る
|