<紀要論文>
回転水中紡糸法で製造された金属細線の形態に及ぼす製線条件の影響

作成者
本文言語
出版者
発行日
収録物名
開始ページ
終了ページ
出版タイプ
アクセス権
JaLC DOI
概要 Metal wires of Pb, Zn and Fe_<77.5>Si_<7.5>B_<15> were produced by the In-Rotating-Water Spinning Method. The effects on the shape of wire of drum velocity (5.2-8.5m/s), jet ejection velocity (3.5-10....0m/s), incidence angle (30, 45, 60 deg) and nozzle diameter (0.1 and 0.2mm) as well as the kind of metals were examined. Pb showed the best spinnability among the tested metals, although the cross section was relatively flat and marked ripples were formed on the wire surface when the incidence angle and jet velocity were relatively large. A long, straight Fe_<77.5>Si_<7.5>B_<15> wire that had smooth surface and round cross-section was obtained with a 0.2-mm-dia. nozzle when the jet velocity and the drum velocity were almost the same. The Fe_<77.5>Si_<7.5>B_<15> wire produced with a 0.1-mm-dia. nozzle however showed the shape like a string of beads.続きを見る

本文情報を非表示

KJ00004507737 pdf 1.13 MB 267  

詳細

レコードID
査読有無
関連情報
ISSN
NCID
タイプ
登録日 2009.04.22
更新日 2017.05.31