Mendeley出力
＜学術雑誌論文＞
Recent Developments in the use of Composites for Knee Cap Prosthetics
| 作成者 | |
|---|---|
| 本文言語 | |
| 出版者 | |
| 発行日 | |
| 収録物名 | |
| 巻 | |
| 号 | |
| 開始ページ | |
| 終了ページ | |
| 出版タイプ | |
| アクセス権 | |
| Crossref DOI | |
| 権利関係 | |
| 概要 | Common knee injuries are ligament tear, meniscus injuries, knee cap fracture and mus-cle strains. The prodrome stage includes pain, swelling, and difficulty in walking. Ligament swelling occurs due to... the overuse of ligaments in particular exercises (such as running, jumping, or walking). Osteoarthritis is one of the most famous joint inflammations affecting the knee and usually requires treatment. Total knee arthroplasty (total knee arthroplasty) is a safe and inexpensive treatment for patients with end-stage arthralgia, with a survival rate of up to 80%. However, partial knee arthro-plasty including kneecap replacement is found to be more effective because it is a less invasive med-ical procedure that requires reconstruction of the knee, the back and the front of the femur. Advances such as Freeman-Swanson’s prosthetic pre-prosthesis (1970) and Kodak-Yamamoto prosthesis (1970) determined future plans, but the original form did not consider the pat bone. In recent years, new manufacturing strategies and new materials have improved the design of kneecap prostheses. Now, it can treat inflammation in both partial and total knee arthroplasty. The use of composite materials for prostheses is increasing at an unprecedented rate. The materials used for such prostheses should not be harmful, chemically and biologically stable, and they should have sufficient mechani-cal strength to withstand physiological stress. Each type of prosthesis produced is manufactured tak-ing into account the individual needs of each customer. This article summarizes the development of composite materials, design strategies and in-depth research on the development and application of kneecap prostheses.続きを見る |
| 目次 | 1.Introduction 2.Fabrication process of Co-Cr prosthesis:electron beam deposition 3 Fabrication technique- 3D Printing 4.Conclusion 5.Future scope |
本文ファイル
| ファイル | ファイルタイプ | サイズ | 閲覧回数 | 説明 |
|---|---|---|---|---|
p1084-1093
|
1.20 MB | 507 |
詳細
| PISSN | |
|---|---|
| EISSN | |
| レコードID | |
| 査読有無 | |
| 主題 | |
| 登録日 | 2023.07.10 |
| 更新日 | 2024.02.21 |