Mendeley出力
＜学術雑誌論文＞
Slip-Ring Induction Motor Torque and Current Ripple Minimization Using Bang-Bang Current Control
| 作成者 | |
|---|---|
| 本文言語 | |
| 出版者 | |
| 発行日 | |
| 収録物名 | |
| 巻 | |
| 号 | |
| 開始ページ | |
| 終了ページ | |
| 出版タイプ | |
| アクセス権 | |
| Crossref DOI | |
| 権利関係 | |
| 概要 | This paper presents a significant improvement in the dynamic performance and control of an isolated slip-ring induction motor (SRIM). The stator windings of this SRIM-based wound rotor motor are conne...cted to a fixed dc voltage PV system through a boost converter (BC) and a two-level three-phase voltage source inverter (VSI). Thus, SRIM is modulated and controlled using a nonlinear ramp bang-bang current-mode technique (RBBCM) with PWM a modulated inverter VSI. Using Simplorer 7, and MATLAB, the experimental and simulation results are investigated and compared between these techniques. The results show the following: the improvement, which can be seen by modulating the fixed frequency and waveform achieved by the inverter; The phase shift between the main component of the load phase voltage and current is almost zero; In addition, the variable hysteresis modulation successfully cancels noise and disturbances while also mitigating both higher and lower-order harmonics. The experimental results are investigated and compared with respect to total harmonic distortion, transient response of SRIM speed and developed torque, and other factors that may affect the SRIM performance.続きを見る |
| 目次 | 1.Introduction 2.Two-level three-phase voltage sourceinverter (VSI) 3.Modulation and control technique for BC-VSI-SRIM 4.Performance and control strategy of SRIMwith VSI and BC 5.Overall simulation results andperformance parameters 6.Conclusion |
詳細
| PISSN | |
|---|---|
| EISSN | |
| レコードID | |
| 査読有無 | |
| 主題 | |
| 登録日 | 2023.07.07 |
| 更新日 | 2024.02.21 |