このページのリンク

引用にはこちらのURLをご利用ください

利用統計

  • このページへのアクセス:12回

  • 貸出数:0回
    (1年以内の貸出数:0回)

<図書>
Sequential analysis of statistical data : applications

データ種別 図書
出版情報 New York : Columbia University Press , 1945
本文言語 英語
大きさ 1 v. (loose-leaf form) ; 29 cm
目次 Sec. 1: Sequential analysis in inspection and experimentation (Introduction)
Sec. 2: Sequential analysis when the result of a single observation is a classification as good or bad and when the result of the test is acceptance or rejection (Binomial distribution)
Sec. 3: Sequential analysis when the result of a single observation is a classification as good or bad and when the result of the test is a decision between two methods or products (Double dichotomies)
Sec. 4: Sequential analysis when the quality being tested is measured and when the question is whether a standard is exceeded (or fallen short of) (Mean of normal distribution, known standard deviation, one-sided alternative)
Sec. 5: Sequential analysis when the quality being tested is measured and when the question is whether a lot differs from a standard (Mean of normal distribution, known standard deviation, two-sided alternative)
Sec. 6: Sequential analysis of variability of quality about the average (Standard deviation of normal distribution, one-sided alternative)
Sec. 7: Sequential analysis when quality is measured by the number of defects per unit and when the question is whether a standard is exceeded (Poisson distribution)
Appendices: Some properties and principles of sequential analysis

所蔵情報



理系図3F 数理独自 P 45/SEQU/K1 1945
027232003225602


理系図 BF 大型本 理農NDC 418/St 2/1 1945
058211981299141

書誌詳細

内容注記 Sec. 1: Sequential analysis in inspection and experimentation (Introduction)
Sec. 2: Sequential analysis when the result of a single observation is a classification as good or bad and when the result of the test is acceptance or rejection (Binomial distribution)
Sec. 3: Sequential analysis when the result of a single observation is a classification as good or bad and when the result of the test is a decision between two methods or products (Double dichotomies)
Sec. 4: Sequential analysis when the quality being tested is measured and when the question is whether a standard is exceeded (or fallen short of) (Mean of normal distribution, known standard deviation, one-sided alternative)
Sec. 5: Sequential analysis when the quality being tested is measured and when the question is whether a lot differs from a standard (Mean of normal distribution, known standard deviation, two-sided alternative)
Sec. 6: Sequential analysis of variability of quality about the average (Standard deviation of normal distribution, one-sided alternative)
Sec. 7: Sequential analysis when quality is measured by the number of defects per unit and when the question is whether a standard is exceeded (Poisson distribution)
Appendices: Some properties and principles of sequential analysis
一般注記 "Prepared by the Statistical Research Group, Columbia University for the Applied Mathematics Panel National Defense Research Committee Office of Scientific Research and Development"
Statistical Research Group (SRG) report 255, section 1-7, appendices - 15th Sep. 1945 - Applied Mathematics Panel (AMP) report 30.2R, section 1-7, appendices
著者標目 Columbia University. Statistical Research Group
書誌ID 1001247412
NCID BA57672443
登録日 2009.09.18
更新日 2009.11.02