| 作成者 |
|
|
|
|
|
|
|
| 本文言語 |
|
| 出版者 |
|
|
|
| 発行日 |
|
| 収録物名 |
|
| 巻 |
|
| 号 |
|
| 開始ページ |
|
| 終了ページ |
|
| 出版タイプ |
|
| アクセス権 |
|
| JaLC DOI |
|
| 関連DOI |
|
|
|
|
|
|
|
| 関連URI |
|
|
|
|
|
|
|
| 関連情報 |
|
|
|
|
|
|
|
| 概要 |
Oxide dispersion strengthend copper (ODS-Cu) alloys Glidcop CuAl15, CuAl25 and Cu-Cr-Zr alloy, were irradiated with Cu$^{2+}$ ions at 573-773K up to dose of 30 dpa. Void swelling was observed in all s...pecimens irradiated in the temperature range between 573K and 673K. In CuAl15 brazed with graphite at 1083K, mean size of grain was about 800nm. Voids were formed in large grains over 1 $mu$m but not in grains less than 500nm. In CuAl25 jointed with SUS316 by Hot Isostatic Pressing (HIP) at 1253K, on the other hand, mean size of grain was order of 10 $mu$m because of remarkable grain growth during HIP at 1253K and showed large void swelling. Small grain size is essential for the suppression of void swelling due to strong sink effects of grain boundaries for the point defects. The Cu-Cr-Zr alloy brazed with graphite at 1083K exhibits less void swelling than other copper alloys in this study. Because of temperature increase during silver brazing, Cu$_5$Zr precipitates were observed. The present results indicate that the control of jointing temperature is essential.続きを見る
|
Mendeley出力
